S10/T10 Blazer 4WD V6-262 4.3L VIN Z (1994)
6. Blower switch, if necessary.
NOTICE: Remove the blower switch knob and spring clip, and remove the blower switch.
Inspect
-
Electrical terminals for corrosion. Remove the corrosion or replace the component as necessary.
-
Temperature and mode levers for freedom of movement. Lubricate, repair, or replace as necessary.
-
Temperature control cable for kinks, binding, and other damage. Repair or replace as necessary.
INSTALL OR CONNECT
1. Heater blower switch, if removed.
-
Hold the blower switch in position and install the spring clip.
-
Install the blower switch knob.
2. Temperature cable.
3. Vacuum connectors, as necessary.
4. Electrical connectors, as necessary.
5. Control assembly (63).
NOTICE: Refer to "Fasteners" under "Vehicle Damage Warnings."
6. Screws (64).
-
Tighten Screws (64) to 1.6 Nm (14 lbs. in.).
7. Check circuit operation.
