S10/T10 Blazer 4WD V6-262 4.3L VIN Z (1994)
Exploded View Of Front Drive Axle.
1. Remove tube and shaft assembly. Refer to TUBE & SHAFT ASSEMBLY. See: Tube & Shaft Assembly
2. Remove bearing using pilot bearing remover tool No. J-34011, or equivalent, Fig. 1.
3. Lubricate new bearing with suitable axle lubricant, then install bearing using pilot bearing installer tool No. J-33482, or equivalent.
4. Reverse procedure to complete installation.
Righthand Output Shaft & Tube
Disassembly
1.
Remove output shaft from tube by tapping inside of flange with a rubber mallet.
2.
Pry tube seal from tube, then remove bearing from tube.
3.
Drive differential shift cable housing seal out of tube using a punch.
