S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Brake Pad: Service and Repair
Front Disc Brakes
GM replacement brake lining material is recommended for this vehicle to maintain the balance between the front and rear brake performance. GM
replacement brake parts have been carefully selected to provide the proper brake balance for the purposes of stopping distance and control over the full
range of operating conditions. Installation of front or rear brake lining material with performance characteristics different from the recommended-GM
replacement parts can change the intended brake balance for this vehicle.
Disc Brake Linings
REMOVE OR DISCONNECT
1
Brake caliper.
^
You do not need to disconnect the brake hose.
2. Suspend the caliper.
NOTE: Do not allow brake components to hang from the flexible hoses, Damage to the hoses could result
3. Caliper mounting bracket (if required)
4. Inboard pad.
5. Retainer spring.
6. Outboard pad.
INSTALL OR CONNECT
1. Caliper mounting bracket
^
Tighten bolts to 110 Nm (81 ft. lbs.).
2. Outboard pad.
3. Retainer spring to the inboard pad.
4. Inboard pad.
5. Brake caliper.
NOTE:
^
Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.