S10/T10 Blazer 4WD V6-4.3L VIN W (1997)
Four Wheel Drive Selector Switch: Service and Repair
Transfer Case Select Switch
Description
Remove or Disconnect
-
Make sure the headlamp switch is in the OFF position.
-
Make sure the ignition switch is in the LOCK position.
1. Transfer case select switch from the instrument panel accessory trim plate.
-
Carefully pry at the edge of the switch with a flat-bladed tool to remove.
2. Electrical connector.
3. Bulb(s) from the transfer case select switch.
Install or Connect
1. Bulb(s) to the transfer case select switch.
2. Electrical connector.
3. Transfer case select switch to the instrument panel accessory trim plate.