S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
crankshaft. The seal must be centered to prevent damage during hub installation.
2. Crankcase front cover (with J 35468 in place) to the block.
3. Crankcase front cover bolts.
TIGHTEN
Crankcase front cover bolts to 11 Nm (97 lbs. in.).
4. Remove J 35468 from the crankcase front cover.
5. Lower radiator hose and clamp at the coolant pump.
6. Crankshaft pulley and hub.
7. Generator and brackets.
8. Drive belt.
9. Upper fan shroud.
10. Power steering reservoir to the radiator shroud.
11. Negative battery cable.