S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
Catalytic Converter: Service and Repair
REMOVE OR DISCONNECT
-
Raise the vehicle.
1. Clamps at the front and rear of the three-way catalytic converter.
2. Three-way catalytic converter to front exhaust pipe and three-way catalytic converter to intermediate exhaust pipe.
3. Three-way catalytic converter.
INSTALL OR CONNECT
^
Apply sealer (GM P/N 9985020) or equivalent at the slip joint connections.
1. Three-way catalytic converter into the exhaust pipe.
2. New U-bolts and clamps at the front and rear of the three-way catalytic converter. Tighten nuts to 50 Nm (37 lbs. ft.).
^
Check for clearance and alignment.
^
Lower the vehicle.
