S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
Blower Motor Resistor: Service and Repair
With A/C
REFER TO TECHNICAL SERVICE BULLETIN NO.: 56-12-05 BEFORE ATTEMPTING THIS PROCEDURE
Blower Motor Resistor
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Electrical connectors.
3. Screws.
4. Blower motor resistor.
INSTALL OR CONNECT
1. Blower motor resistor.
NOTICE: Refer to "Fasteners" under "Vehicle Damage Warnings."
2. Screws.
-
Tighten screws to 1.9 Nm (17 lbs. in.).
3. Electrical connectors.
4. Negative battery cable.
-
Check circuit operation.
