S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
Crankshaft Position Sensor: Service and Repair
Ignition Coil Assembly And CKP Sensor
REMOVE OR DISCONNECT
1. Sensor harness connector at module.
2. Sensor to block bolt (1).
3. Sensor from engine.
INSPECT
^
Sensor 0-ring for wear, cracks or leakage. Replace if necessary. Lube new 0-ring with engine oil before installing.
INSTALL OR CONNECT
1. Sensor into hole in block.
2. Sensor to block bolt (1).
^
Torque to 8 Nm (71 lb. in.).
3. Sensor harness connector at module.