S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
4. Lower control arm out of the opening in the splash shield.
-
Using a putty knife or similar tool to guide control arm past splash shield.
IMPORTANT: Block the knuckle assembly out of the way by placing a wooden block between the frame and upper control arm.
5. Grease fittings.
6. Lower ball joint from the lower control arm.
-
Using tools as shown.
-
Replace parts as necessary.
INSPECT
The tapered hole in the steering knuckle and remove any dirt. If the hole is out of round, deformed or damaged, the knuckle must be replaced.
