S10/T10 P/U 2WD L4-2.2L VIN 4 (1995)
Clutch Pedal Assembly: All Technical Service Bulletins
Clutch - Pedal Noise, Squeak (Install Greaseable Stud)
Bulletin No.: 16-73-01
File in Section: 7 - Transmission
Date: March, 1995
SUBJECT:
Clutch Pedal Noise, Squeak (Install Greaseable Stud)
MODELS:
1984-95 Chevrolet and GMC Truck S/T Models
with Borg-Warner 5-Speed Manual Transmission (ML2, ML3, MW1) and 2.2L, 2.5L, or 2.8L Engine (VINs E, R, A, 4 - RPOs LN2, L38, LN8, LL2)
This bulletin is being revised to add 1992-95 model years and to update parts information. Previous divisional publication numbers were:
Chevrolet
91-197A-7C
GMC Truck 91-7C-164
GM Canada 91-7050101
CONDITION
Some owners may experience a clutch pedal squeak. This noise usually stops when a slight amount of pressure is applied to the clutch pedal.
CAUSE
The noise or squeak is caused by a dry contact area between the clutch fork and ball stud. This results in metal to metal contact.
CORRECTION
Install a greaseable ball stud. Greaseable ball studs entered production December 1994 and can be identified by a grease fitting on the right side of the
clutch housing.
Service Procedure
1. Remove transmission, slave cylinder, flywheel housing and clutch fork.
^
Complete removal directions can be found in Sections 7B and 7C of the appropriate S/T Service Manual.
2. Remove the ball stud from the flywheel housing.
