S10/T10 P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
1. Lubricate the new O-ring using clean refrigerant oil.
2. Install the new O-ring into the groove in the switch cavity.
3. Lubricate the control switch housing using clean refrigerant oil.
4. Install the switch (4) into the switch cavity until the switch bottoms in the cavity.
5. Using the J 5403, install the switch retaining ring.
Ensure that the high point of the curved sides is adjacent to the switch housing. Ensure that the retaining ring is properly seated in the switch cavity
retaining groove.
6. Leak test according to bench test procedure.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID".
See: Application and ID/RPO Codes
