S10/T10 P/U 2WD L4-2.2L VIN 5 Flex Fuel (2001)
Tighten
Tighten the wiper motor mounting screws to 6.5 N.m (57 lb in).
2. Connect the electrical connector.
IMPORTANT:
^
Lubricate the socket with white lithium grease (GM P/N 9985885) or equivalent.
^
The wiper transmission must be assembled to the crank arm past the second detent so the seal is compressed to a maximum height of 25.5 mm (1
in).
3. Install the transmission drive link socket onto the crank arm ball of the wiper motor using the J 39529.
4. Install the air inlet grille panel.
5. Install the wiper arms.
