S10/T10 P/U 2WD V6-262 4.3L VIN W CPI (1992)
Fluid - A/T: Service and Repair
Turbo Hydra-Matic 3L30 (180C)
Draining Bottom Pan
1.
Raise and support vehicle.
2.
Position a suitable drain pan below transmission oil pan.
3.
Remove front and side oil pan bolts.
4.
Loosen rear bolts and gently pry the pan down to allow fluid to drain.
5.
Remove remaining bolts and pull pan away from case carefully, as there will still be fluid contained in the pan.
6.
Drain remaining fluid from pan, then remove gasket, oil filter retaining bolts, oil filter and seal.
7.
Using solvent, thoroughly clean oil pan and gasket surfaces, then air dry.
8.
Install new oil seal and filter into case. Torque attaching bolts to 13-15 ft. lbs.
9.
Install oil pan with new gasket and torque bolts to 7-10 ft. lbs.
10.
Add transmission fluid, then with engine idling and brakes applied, move selector lever through each gear range and return selector lever to Park.
11.
Bring fluid to proper operating temperature and check fluid level, adding as required to bring level to the Full mark.
Adding Fluid to A Dry Transmission
1.
Add transmission fluid.
2.
With transmission in Park, start engine and let engine idle (carburetor off fast idle cam.)
3.
Apply brakes and move shifter lever through each gear range, then with transmission in Park, add additional fluid as required to bring the level up
to Full mark on dipstick.
