S10/T10 P/U 2WD V6-262 4.3L VIN W CPI (1992)
^
Raise the window to the full up position secure the glass to the door frame using cloth backed tape.
1. Door trim panel.
2. Armrest bracket.
3. Water deflector.
4. Battery ground cable.
5. Wire harness from motor.
6. Regulator lift arm roller from the window mount sash.
CAUTION: Sector gear must be locked into position. Regulator lift arm is under tension from the counterbalance spring and could cause
personal injury if the sector gear is not locked in position.
Drilling Hole In Window Regulator. (97 Shown, This Model Similar)
Using A Bolt And Nut To Lock Window Regulator. (97 Shown, This Model Similar
NOTE: The Manufacturer did not provide a specific image for this year. The two images above are from a 1997 model but are typical.
7. Motor from window regulator.
^
Drill hole through the regulator sector gear and backplate install bolt and nut to lock sector gear in position.
^
Drill Out the motor mounting rivets.
INSTALL OR CONNECT
TOOL REQUIRED:
^
J-9022-A, Rivet Installer
1. Motor to the regulator.
2. Rivets to the motor and regulator.
^
Use tool J-9022-A.
^
Install 4.8 mm (3/16-inch) rivets.
^
Remove nut and bolt used to lock the sector gear in position.
