S10/T10 P/U 2WD V6-262 4.3L VIN Z TBI (1995)
Distributor: Service and Repair
Distributor Disassembly & Assembly
With OBD II
CAUTION: The distributor driven gear can be installed in two positions. Make sure when installing the gear that the dimple found below the roll pin
hole in the gear is on the same side as the rotor segment. The dimple will not align directly with the rotor segment if not, the gear is Installed 180° off
and a no start condition may occur. Premature wear and damage may result.
Distributor Components
REMOVE OR DISCONNECT
1. Two screws holding the cap to the housing.
2. Cap from the housing.
3. Two screws from the rotor.
4. Rotor.
Vane Wheel In Distributor
^
Note which locating holes (B) the rotor was removed from.
5. Two screws holding the hail effect switch.
6. Hall effect switch.
^
The square cut hole (C) in the vane wheel must be aligned with the hall effect switch in order to remove the switch.
