S10/T10 P/U 4WD L4-151 2.5L (1985)
4.
Remove the retention spring from the mirror bracket (Figure 2, Item A).
5.
Drill and tap the retention spring, on the rear side wing, so that it will accept a 6.0 mm X 1.0 mm (diameter X thread pitch) set screw fastener
(Figure 3, Item A) (procured locally). The approximate fastener length should be 10 mm.
NOTE:
The hole must be drilled perpendicular to the flat surface of the retention spring's wing.
6.
Reinstall the retention spring in the mirror bracket.
7.
Reinstall the mirror head and arm to the mirror bracket.
8.
Reinstall the mirror assembly to the door.
9.
Install the 6.0 mm X 1.0 mm headed fastener, adjusting it to obtain the original pressure against the mirror arm. DO NOT over-torque this fastener.
10.
Reinstall the screws which secure the mirror cover to the door.
WARRANTY INFORMATION
For vehicles repaired under warranty, use:
Labor
Description
Labor Time
Operation
R3260
RH mirror R&R
0.4 Hr.
