S10/T10 P/U 4WD L4-151 2.5L (1985)
21.
Lubricate the seal lip.
-
If seal is cut or torn, inspect the wheel bearing for damage and replace the seal.
22.
If necessary, replace the seal as follows:
-
Pry old seal from knuckle and discard.
-
Lubricate the new seal lip.
-
Use a flat plate to press the seal down flush with the knuckle.
Tripot Housing/Tripot Seal Replacement
Figure 10 - Inboard Joint Disassembly
Required Tools:
J8059 Snap Ring Pliers J35910 Seal Clamp Tool
1.
Place halfshaft in vise (use protective covers over vise jaws).
2.
Remove seal clamp protectors (Figure 10) if used, from inner C/V joint and cut clamp(s) from seal with a pair of side cutters. For swage ring
removal use a hand grinder to cut through the ring (taking care not to damage the housing).
3.
Remove tripot housing from halfshaft and wipe grease from tripot assembly roller bearings and housing. Thoroughly degrease the housing and
allow to dry prior to assembly.
Important:
Handle tripot spider assembly with care. Tripot balls and needle rollers may separate from spider trunnions.
4.
Slide seal up on the shaft and inspect rollers, needle bearings, and trunnions. Check housing for unusual wear, cracks, and other damage. Replace
housing and/or tripot assembly as needed.
