S10/T10 P/U 4WD L4-151 2.5L (1985)
^
Place the offset lever (659) and detent spring (660) over the detent ball (662).
^
Slide the extension housing against the transmission case while guiding the offset lever (659) over the shift shaft.
2.
Extension to case bolts.
^
Apply sealer to threads of top 2 bolts.
^
Tighten bolts to 30 N-m (25 lbs.ft.).
3.
Offset lever roll pin (663).
4.
Speed sensor.
5.
Transmission.
^
Refer to Section 7B of the appropriate S/T Service Manual for complete transmission installation procedure.
^
Refill transmission with fluid.
Figure 3 - Dampener Assembly
6.
Damper to transmission as shown in Figure 3.
^
Be sure damper is installed facing in the proper direction.
^
Tighten bolts (2) to 45 N-m (35 lbs.ft.).
^
Tighten weight bolt (5) to 100 N-m (75 lbs.ft.).
SERVICE PARTS INFORMATION
Part Number
Description
15674891
Damper Kit, Driveline Vibration
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicle repaired under warranty use:
Labor Operation:
T7156
Labor Time:
2.6 hrs