S10/T10 P/U 4WD L4-151 2.5L (1985)
1.
Disconnect the negative battery cable.
2.
Open the endgate to the horizontal position.
3.
Remove the inner trim panel.
4.
Remove the bolts retaining the endgate inner panel reinforcement and remove the reinforcement (Figure 1, Item 2).
5.
Disconnect the right and left endgate lock rods from the endgate window latch assembly (Figure 2).
6.
Remove the adjusting nuts securing the window latch assembly to the endgate. (Figure 1, Item 4)
7.
Disconnect the power window release actuator cable, if equipped.
8.
Remove the window latch assembly from the endgate and discard.
9.
Preassemble the lock rods to the new endgate window latch assembly (P/N 20367780) and install. DO NOT force the lock rods into position. The
lock rods should line up with the attaching hole or stud on the window latch lever.
NOTE:
The temporary lock md positioning fastener must be in place for this procedure. (Figure 2, Item 4)
If the rods do not align with the attaching hole or stud, adjust the rod(s) by turning to either lengthen or shorten as required.
10.
Remove and discard the temporary lock rod positioning fastener
11.
Reconnect the power window release actuator cable, if equipped.
12.
Check for proper endgate operation. If necessary, readjust the lock rods.
13.
Reattach the endgate inner panel reinforcement.
14.
Adjust the latch assembly as described in steps 1-3 of the "Adjusting Procedure".
15.
Reinstall the inner trim panel.
16.
Reconnect the negative battery cable.
SERVICE PARTS INFORMATION
PART NUMBER
DESCRIPTION
QUANTITY
20367780
Window Latch Assembly
1
Parts are currently available from GMSPO.
WARRANTY INFORMATION
For vehicles repaired under warranty use:
Labor Operation:
B5880
Use applicable labor time guide for labor hours.
