S10/T10 P/U 4WD V6-173 2.8L (1986)
FIGURE 5 - REVISED VACUUM SYSTEM
10.
Apply pipe thread sealant to the nut on the pipe assembly (P/N 10069245) and assemble the pipe assembly to the manifold fitting. Install vacuum
hose (P/N 15602667) to the manifold pipe and secure with the clamp. See Figure No. 5.
FIGURE 6 - MOUNTING BOOSTER ASSEMBLY TO COWL PANEL
11.
Install adapter plate and new seal on booster mounting studs. Install brake booster assembly on the vehicle. Torque booster nuts to 20 N-m (15
ft.lbs.). See Figure No. 6.
12.
Reinstall booster pushrod.
13.
Reinstall brake master cylinder and proportioning valve to the booster. Torque nut to 27 N-m (20 ft.lbs.).
14.
Connect the hose assembly, to the booster check valve.
15.
Install the air cleaner adapter and new gaskets.
16.
Connect the battery cable.
