S10/T10 P/U 4WD V6-173 2.8L (1986)
damaged oil pickup unit.
4. Support the engine with a suitable jack. Do not load the engine mounting.
5. Engine mounting through-bolt and nut.
CAUTION Raise the engine only enough for sufficient clearance. Check for interference between the rear of the engine and the dash panel which could
cause distributor damage.
6. Raise the engine only enough to permit removal of the engine mounting.
7. Mounting assembly bolts, nuts, and washers.
8. Mounting assembly.
INSTALL OR CONNECT
1. Mounting assembly.
2. Mounting assembly bolts, nuts, and washers.
Tighten
^
Bolt to 56 Nm (41 ft. lbs.).
^
Nut to 47 Nm (35 ft. lbs.).
3. Engine mount through-bolt and nut. Lower the engine until the bolt can be inserted. Install the nut.
Tighten
^ Through-bolt nuts to 115 Nm (85 ft. lbs.) or nuts to 72 Nm (53 ft. lbs.).