S10/T10 P/U 4WD V6-173 2.8L (1986)
FIGURE 6 - MOUNTING BOOSTER ASSEMBLY TO COWL PANEL
11.
Install adapter plate and new seal on booster mounting studs. Install brake booster assembly on the vehicle. Torque booster nuts to 20 N-m (15
ft.lbs.). See Figure No. 6.
12.
Reinstall booster pushrod.
13.
Reinstall brake master cylinder and proportioning valve to the booster. Torque nut to 27 N-m (20 ft.lbs.).
14.
Connect the hose assembly, to the booster check valve.
15.
Install the air cleaner adapter and new gaskets.
16.
Connect the battery cable.
NOTE:
ALWAYS ENSURE THAT THE BRAKE SYSTEM IS OPERATIONAL AFTER PERFORMING BRAKE WORK BEFORE RETURNING
THE VEHICLE TO THE CUSTOMER.
PARTS LIST
Power Brake Kit
(1)
15602668
Kit consists of
Fitting
14102142
Pipe Assembly
10069245
Hose Assembly
15602667
Booster Assembly
18014642
Check Valve Kit
18012017
Adapter Plate
15602644
Seal
14030819
Instruction Sheet
15602669
Use T Op 7375 when performing these procedures. Labor times are as follows:
Check minimum idle speed,
1.0 hr.
Check TPS sensor numbers, Check TPS voltage and install power brake kit.