chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Recall - Incorrect Certification Label|Page 1291 > < Recall - Incorrect Certification Label|Page 1289
Page 3
background image

INSPECT & INSTALL NEW

00

V3660

0.2

0.1

CERTIFICATION LABEL

*Campaign Administrative Allowance

Dealers will automatically recieve the correct labor allowance based on the labor operation performed.

Refer to the Chevrolet Claims Processing Manual for details on Product Campaign Claim submission.
Notification Used By Chevrolet Motor Division

Dear Chevrolet Truck Owner:

This notice is sent to you in accordance with the requirements of the National Traffic and Motor Vehicle Safety Act.

General Motors has determined that certain 1986 Chevrolet S/T Light Duty model trucks built at Moraine Truck Assembly do not conform to the
requirements of Federal Motor Vehicle Safety Standard (FMVSS) 120, "Tire Selection and Rims for Vehicles Other Than Passenger Cars." The trucks
were assembled correctly except that the tire and wheel information on the certification label may be incorrect. Specifically, all the 5's were changed to
6's (i.e. P195/75R14 read P196/76R14 and 15 x 6JJ read 16 x 6JJ).

To correct this noncompliance, a new certification label should be installed on the affected vehicles. We have enclosed a new certification label. For
your convenience, you may install it yourself. Just follow the instructions on the reverse side of this letter.

If you prefer, you may arrange a service date with your Chevrolet Dealer. They will be pleased to install the new label for you at no charge.

If you decide not to install the new label yourself, your Chevrolet Dealer is best equipped to provide service to ensure your vehicle is corrected as
promptly as possible. However, if you take your vehicle to your dealer on the agreed service date and they do not remedy this condition on that date or
within five days, we recommend you contact the nearest Chevrolet Zone Office. The Zone Office will assist you and the dealer in getting your vehicle
corrected. The locations and telephone numbers of the Zone Offices are listed in your Owners Manual.

After contacting your dealer and the Zone Office, if you are still not satisfied that we have done our best to remedy this condition without charge and
within a reasonable time, you may wish to write the Administrator, National Highway Traffic Safety Administration, 400 Seventh St., S.W., Washington,
D.C. 20590 or call 800-424-9393 (Washington, D.C. residents use 426-0123).

If you install the new certification label or if you have sold or traded your vehicle, please complete the enclosed postage paid owner reply card and mail
it to us. This will assist us in assuring that all affected vehicles have been corrected.

We are sorry to cause you this inconvenience; however, we have taken this action in the interest of your safety and continued satisfaction with our
products.

Chevrolet Motor Division GENERAL MOTORS CORPORATION

Enclosure
ADMINISTRATIVE PROCEDURE

REFER TO THE CURRENT CHEVROLET SERVICE POLICIES AND PROCEDURES MANUAL AND CLAIMS PROCESSING MANUAL FOR
CAMPAIGN HANDLING AND ADMINISTRATIVE PROCEDURES.

Recall - Incorrect Certification Label|Page 1291 > < Recall - Incorrect Certification Label|Page 1289