S10/T10 P/U 4WD V6-173 2.8L (1986)
FIGURE NO. 3 - POWER DOOR LOCK THUMB LEVER ASSEMBLY
^
Cut lock rod insulator strip in half lengthwise (Figure No. 3).
Power Window And Door Lock Switch Wiring
^
Inspect for any power window and door lock switch wiring that may be contacting the door lock rods in the area behind the door lock lever. If
contact exists, move the wiring so that it does not contact the door lock rods or manual lock barrel in housing assembly.
Power Door Lock Effort
^
Remove power door lock thumb lever assembly (Figure No. 3) and check for binding or tightness of lock thumb lever. If binding or tightness
exists, replace lever assembly, making sure thumb lever has no friction load on roll pin to housing, before new lever assembly is installed.
Door Lock Rod Guides
^
Lubricate both lock rod guides as shown in Figure No. 3.
