S10/T10 P/U 4WD V6-173 2.8L VIN B 2-bbl (1983)
Engine Mount: Service and Repair
Fig. 1 Engine mount installation
1.
Disconnect battery ground cable.
2.
Remove top half of fan shroud.
3.
Raise and support vehicle.
4.
Remove mount through bolt, then raise front of engine and remove mount, Fig. 1. Do not raise engine any more than is needed to provide
sufficient clearance. Also, check for interference between rear of engine and cowl panel which could damage the distributor.
5.
Reverse procedure to install.
