S10/T10 P/U 4WD V6-262 4.3L VIN Z (1992)
PARTS INFORMATION
NOTICE:
Each dealer will be preshipped one of each oil filter assembly with adapter (see below) during the week of February 8, 1993.
Parts required to complete this campaign are to be obtained from General Motors Service Parts Operations (GMSPO). To ensure these parts will be
obtained as soon as possible, they should be ordered from GMSPO on a "C.I.O" order with no special instruction code, but on an advise code (2).
Service Procedure
1.
Raise hood.
2.
For L35 CPI (Central Port Injection) Engines, remove two (2) wingnuts from remote air cleaner box and move air cleaner box aside.
3.
Disconnect engine oil lines from adapter. Save O-rings for possible re-use at re-assembly.
4.
If vehicle is equipped with an engine oil cooler, disconnect oil cooler lines from adapter. Save O-rings for possible re-use at re-assembly.
5.
Remove oil filter adapter from body with oil filter still attached.
6.
Install new remote oil filter adapter assembly to body with new oil filter still installed to adapter as provided in kit.
7.
Inspect both sets of O-rings for cuts and other imperfections, and replace O-rings (P/N 15564870) as required.
8.
If vehicle is equipped with an engine oil cooler, reconnect oil cooler lines using O-rings.
9.
Reconnect engine oil lines using O-rings.
10.
Drain engine oil from crankcase.
11.
Fill crankcase with new engine oil (approximately 4-1/2 quarts).
12.
Run engine and inspect connections for leaks.
13.
Install Campaign Identification Label.
14.
Close hood.
Campaign ID Label and Claim Information