S10/T10 P/U 4WD V6-4.3L VIN X (1996)
Crankshaft Main Bearing Seal: Service and Repair
Rear oil seal installation
1. Remove transmission. Refer to Transmision and Drivetrain / Manual Transmission/Transaxle / Service and Repair.
Refer to Transmision and Drivetrain / Automatic Transmission/Transaxle / Service and Repair.
2. Remove clutch and flywheel, if equipped.
3. Remove rear crankshaft oil seal by placing screwdriver in notches provided and pry the seal out.
4. After cleaning groove, apply a thin even coat of adhesive, part No. 1052621, Loctite 414 or equivalent over entire surface of seal groove.
5. Within one minute install seal using seal installer J-35621 or equivalent, Fig. 17.
6. Reverse steps 1 and 2 to complete installation.
