S10/T10 P/U,Blazer L4-119 1.9L (1982)
Stabilizer Bar: Service and Repair
Fig. 19 Stabilizer bar replacement. 4 x 2 models
4 X 2 MODELS
1.
Raise and support front of vehicle.
2.
Remove stabilizer link bolt nuts from both sides, then pull link bolt from linkage and remove retainers, grommets and spacers, Fig. 19.
3.
Remove stabilizer bracket to frame or body attaching bolts, then the stabilizer bar, bushings and brackets.
4.
Reverse procedure to install, noting the following: install stabilizer bar so the identification stamping appears on the right side of vehicle. Position
the rubber bushings squarely in the brackets with the slit facing the front of vehicle. Torque link nuts to 13 ft. lbs. and bracket bolts to 24 ft. lbs.
