Silverado 1500 2WD V6-4.3L (2007)
1. Install a NEW front cover.
Notice: Refer to Fastener Notice.
2. Install the front cover bolts.
Tighten the bolts to 12 N.m (106 lb in).
Important: Do not reuse the original O-ring seal.
3. If reinstalling the old CMP sensor, install a NEW O-ring seal onto the sensor.
4. Install the CMP sensor to the wiring harness jumper.
5. Connect the CMP sensor wiring harness jumper to the CMP sensor.
6. Lubricate the O-ring seal with clean engine oil.
7. Install the CMP sensor and wiring harness jumper to the engine front cover.
8. Install the CMP sensor bolt.
