Silverado 1500 2WD V6-4.3L (2007)
2. This step applies to Bartholomew style connector ONLY. Squeeze the plastic quick connect fitting release tabs.
3. This step applies to Release Tab style connector ONLY. Release the fitting by pushing the tab toward the other side of the slot in the fitting.
4. This step applies to the Squeeze to Release style connector ONLY. Squeeze where indicated by the arrows shown above on both sides of the
plastic ring surrounding the quick connect fitting.
5. This step applies to the Sliding Retainer style connector ONLY. Release the fitting by pressing on one side of the release tab causing it to push in
slightly. If the tab does not move try pressing the tab in from the opposite side. The tab will only move in one direction.
