Silverado 1500 2WD V6-4.3L (2007)
11. Remove the EVAP canister vent solenoid clip (1) from the chassis EVAP line and secure out of the way.
12. Remove the EVAP canister vent solenoid pipe clip (2) from the chassis EVAP line.
13. Disconnect the fuel tank EVAP line quick connect fitting from the chassis line.
14. Disconnect the fuel tank fuel feed line quick connect fitting from the chassis line.
15. Cap the fuel and EVAP lines in order to prevent possible fuel and/or EVAP system contamination.
16. Unclip the inline harness connector from the bracket.
17. Remove the fuel line bracket bolt (1).
18. Remove the fuel/EVAP line clip nut (2).
19. Loosen the brake pressure modulator valve (BPMV) bolts. Slide the BPMV off of the frame and reposition the BPMV without disconnecting the
brake lines.
20. Unclip the line assembly from the frame.
21. Remove the fuel/EVAP line clips from the frame and crossmember.
22. Remove the fuel/EVAP line assembly from the vehicle.
Installation Procedure
