Silverado 1500 2WD V6-4.3L (2007)
1. Install the following NEW components to the fuel meter body:
*
Lower fuel seal (4)
*
Spacer ring (3)
*
Upper fuel seal (2)
*
Fuel seal retainer (1)
Caution: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the
risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the
O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
2. Apply a few drops of clean engine oil to the fuel pipe end.
3. Install the fuel pipe to the fuel meter body.
4. Install the fuel pipe retainer.
