Silverado 1500 2WD V6-4.3L (2007)
Inspect how the IP branch to C202 is routed. Reroute the wiring as necessary to match the correct routing in the photo above. In order to route the IP
harness branch correctly (behind the junction block-left I/P): Remove the cover from the junction block-left I/P, unseat the junction block from the
bracket. Disconnect C202. Route the harness such that it lays between the goalposts of the junction block bracket. Seat the junction block to the bracket
(harness will now be under the junction block). Secure the harness by seating the grey offset retaining clip to the dashmat (or brown "buddy clip" if
present - usually on SUV's only). Reconnect C202.
Make sure that the grey offset retaining clip (off of the IP branch going to C202) is seated into the hole in the dashmat or into the brown buddy clip (if
present), securing the IP branch to the vehicle.
If the harness is still in contact with a sharp edge or point of the park brake assembly, protect the harness by routing it away from the contact point and
holding it there with tie straps, and/or covering the sharp edge with butyl tape.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
