Silverado 1500 2WD V6-4.3L (2007)
Power Steering Line/Hose: Service and Repair
Power Steering Gear Inlet Pipe/Hose Replacement (Gas With Hydroboost)
Power Steering Gear Inlet Pipe/Hose Replacement (Gas With Hydroboost)
Removal Procedure
1. Install drain pans under the vehicle as needed.
Notice: Refer to Power Steering Hose Disconnected Notice.
Important: Note the routing of the power steering gear inlet hose before removal. It MUST be routed correctly upon installation.
2. Remove the power steering gear inlet hose (2) from the power brake booster (1).
3. Remove the power steering gear inlet hose (2) from the power steering gear.
4. Remove the power steering gear inlet hose (2) from the vehicle.
Installation Procedure
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
