Silverado 1500 2WD V6-4.3L (2007)
5. Remove the steering shaft coupling nut (1) and bolt (2) at the steering column.
6. Remove the upper intermediate steering shaft from inside the engine compartment.
Installation Procedure
Important: If a new steering shaft coupling is being installed then transfer the position of the alignment marks from the old component to
the same locations on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after
installation.
1. Install the upper intermediate steering shaft from inside the engine compartment.
Notice: Refer to Fastener Notice.
2. Install the steering shaft coupling nut (1) and bolt (2) at the steering column.
Tighten the nut and bolt to 62 N.m (46 lb ft).
