Silverado 1500 2WD V6-4.3L (2007)
2. Obtain J 43909 and remove the inner sleeve so that the tool will slide over the manual shift shaft.
3. Slide the J 43909 into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909 and drive the new seal
into the seal bore until the seal is seated at the bottom of the bore.
Power Take-Off Cover Gasket Replacement
Power Take-Off Cover Gasket Replacement
Removal Procedure
1. Remove 6 bolts (3).
2. Remove the power take-off (PTO) cover (2) and gasket (1). Discard the used gasket.
3. Ensure the PTO gasket face on the transmission case is free of all foreign material, nicks, and scratches.
Installation Procedure
1. Install the new PTO cover gasket (1) and cover (2).
Notice: Refer to Fastener Notice.
2. Start the top-center bolt (3) first. Install the other 5 bolts.
Tighten all bolts to 43 N.m (32 lb ft).
Rear Propshaft Shaft Seal Replacement
Rear Propshaft Shaft Seal Replacement
Tools Required
*
J 24171-A Seal and Dust Shield Remover
*
J 43782 Rear Seal Installer
Removal Procedure
