Silverado 1500 2WD V6-4.3L (2007)
4. Drive the outer bearing cup into the wheel hub using the J 44419 (2) and the J 8092 (1).
Drive the outer bearing cup into the wheel hub until it is just past the retaining ring groove. Do not bottom out the bearing assembly in the bore.
5. Install the retaining ring into the groove. Make sure the retaining ring is fully and evenly seated in the groove.
6. Turn the wheel hub over and seat the outer bearing assembly against the retaining ring using the J 24426 (2) and the J 8092 (1).
7. Ensure that the outer bearing assembly rotates freely in the hub.
8. Turn the wheel hub over and install the inner bearing cup.
