Silverado 1500 2WD V6-4.3L (2007)
5. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice.
6. Install the yoke retainers (7) and the bolts (6).
Tighten the yoke retainer bolts to 25 N.m (18 lb ft).
7. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
8. Using the J 43218 to crimp both clamps.
9. Lower the vehicle.
