Silverado 1500 2WD V6-4.3L (2007)
5. Remove the bolts (1) and the yoke retainers (2) from the rear axle pinion yoke (4).
Notice: When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke and
the universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the
joint.
6. Slide the rear propeller shaft forward in order to remove the propeller shaft from the rear axle pinion yoke.
7. Slide the rear propeller shaft rearward in order to disconnect the rear propeller shaft from the front propeller shaft stub shaft.
8. Remove the rear propeller shaft from the vehicle.
9. Remove the boot from the front propeller shaft stub shaft, if applicable.
10. Remove the center bearing support nuts (1).
11. Remove the center bearing support (2).
12. Remove the front propeller shaft by sliding the front propeller shaft rearward from the transmission or the transfer case, w/o RPO MW7.
13. Remove the bolts and the yoke retainers from the transmission pinion yoke, w/RPO MW7.
14. Remove the front propeller shaft by disconnecting the front propeller shaft from the transmission pinion yoke, w/RPO MW7.
Installation Procedure
