Silverado 1500 2WD V6-4.3L (2007)
1. Install the front propeller shaft by sliding the front propeller shaft into the transmission or the transfer case, w/o RPO MW7.
2. Install the front propeller shaft to the transmission pinion yoke, w/RPO MW7.
Important:
*
Align the reference marks made during removal.
*
Tighten the bolts until snug. Do not torque the bolts at this time.
Install the yoke retainers and the bolts, w/RPO MW7.
3. Install the center bearing support (2).
Notice: Refer to Fastener Notice.
4. Install the center bearing support nuts.
Tighten the bearing support nuts to 40 N.m (30 lb ft).
5. Tighten the yoke retainer bolts, w/ RPO MW7.
Tighten the yoke retainer bolts to 25 N.m (18 lb ft).
6. Inspect the splines of the front propeller shaft stub shaft for a sufficient coating of grease. If the splines of the stub shaft does not have a sufficient
coating of grease, lubricate the shaft with chassis grease, GM P/N 12377985 or equivalent.
