Silverado 1500 2WD V6-4.3L (2007)
Seals and Gaskets: Service and Repair
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Rear Axle Hub, Bearing, Cup, and/or Seal Replacement
Tools Required
*
J 8092 Universal Driver Handle - 3/4 inch - 10
*
J 2222-C Wheel Bearing Nut Wrench
*
J 24426 Wheel Bearing Race Installer - Outer
*
J 24427 Wheel Bearing Race Installer - Inner
*
J 44419 Hub Outer Bearing Race Installer
*
J 44420 Differential Bearing and Hub Seal Installer
Removal Procedure
Important: The wheel hub seal must be replaced anytime the wheel hub assembly is removed from the axle housing.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake caliper bracket. It is not necessary to remove the brake caliper from the bracket.
4. Remove the axle shaft.
5. Remove the axle nut retaining ring.
6. Remove the key.
7. Remove the adjusting nut using the J 2222-C.