Silverado 1500 2WD V6-4.3L (2007)
14. After this procedure has been performed, issue a check to the customer of record (see the Q&A section in this bulletin for additional details).
Involved vehicles that are currently in dealer/retailer new or used car inventory are not eligible for a check. However, all new vehicles currently in
dealer/retailer inventory will be re-invoiced with appropriate dealer credit for the elimination of this feature.
2008-2009 HUMMER H2
1. Open the hood and disconnect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in SI.
Note
The underhood fuse block in the engine compartment is located on the driver side of the vehicle near the battery. Lift the cover for access to the
fuse/relay block. Refer to Underhood Fuse Block in the Owner's Manual for fuse information.
2. Locate the underhood bussed electrical center (UBEC).
3. Remove the UBEC cover and locate the 60 amp heated windshield washer fuse.
4. Remove the two relays next to the fuse to gain access to the fuse.
5. Remove the 60 amp heated windshield washer fuse using needle-nose pliers.
6. Discard the 60 amp heated windshield washer fuse.
7. Install the two relays removed in Step 4.
8. Refer to Windshield Washer Solvent Heater Removal in this bulletin. After completing the Windshield Washer Solvent Heater Removal service
procedure, proceed to step 9 in this section of the bulletin.
9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in SI.
10. Test the operation of the windshield wiper system.
1. Ensure the wiper system functions in low and high positions.
2. Verify that the windshield wiper/washer switch functions. The windshield wiper system should provide wiper fluid to the windshield.
3. Verify that the heated windshield washer switch does NOT flash.
11. Secure the UBEC cover on the UBEC.
12. Close the hood.
13. Make a copy of the Owner Manual Supplement, located at the back of this bulletin, and place it in the glove box.
Note
Involved vehicles that are currently in dealer/retailer new car inventory are to receive a corrected Monroney Label (MSRP window sticker). It is
the responsibility of the Service Manager to ensure this label replacement occurs as soon as possible.
14. After this procedure has been performed, issue a check to the customer of record (see the Q&A section in this bulletin for additional details).
Involved vehicles that are currently in dealer/retailer new or used car inventory are not eligible for a check. However, all new vehicles currently in
dealer/retailer inventory will be re-invoiced with appropriate dealer credit for the elimination of this feature.
2008-2009 Buick Enclave