Silverado 1500 2WD V6-4.3L VIN X (2004)
6. Disconnect the following electrical connectors:
^
The air conditioning (A/C) compressor clutch (1), if equipped
^
The A/C pressure switch (4), if equipped
7. Remove the engine wiring harness clip (3) from the accelerator control cable bracket.
8. Remove the accelerator control cable bracket nuts.
9. Remove the accelerator control cable bracket with the cables attached, from the throttle body.
10. Reposition and secure the bracket and cables out of the way.
11. Disconnect the following electrical connectors:
^
The throttle position (TP) sensor (1)
^
The idle air control (IAC) motor (2)
^
The control port injector module (3)
12. Remove the engine wiring harness clip bolt (4).
13. Disconnect the following electrical connectors:
^
The evaporative emission (EVAP) canister purge solenoid valve (1)
^
The manifold absolute pressure (MAP) sensor (2)
