Silverado 1500 2WD V8-4.8L VIN V (2006)
2. Connect the wire connector.
3. Install the 4 retaining screws. Ensure the screw follows the same thread in the screw boss so that a new thread is not formed.
Tighten the screws to 6 N.m (53 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
4. Move the console forward in order to connect the wire connector.
5. Install the console to the I/P.
6. Install the 2 front seats.
Front (Windshield Pillar Speaker)
SPEAKER REPLACEMENT - FRONT (WINDSHIELD PILLAR SPEAKER)
REMOVAL PROCEDURE
1. Remove the windshield garnish molding (2).
2. Disconnect the electrical connector (3) to the speaker.
3. Remove the speaker (1) by press until it is out of the molding.
INSTALLATION PROCEDURE
1. Press in the speaker (1) until it is fully seated.
2. Connect the electrical connector (3).
3. Install the windshield garnish molding (2).
Front Door
