Silverado 1500 2WD V8-4.8L VIN V (2006)
5. Remove the two trim panel screws.
6. Remove the trim panel from the door by carefully sliding the panel upward then outward.
7. Disconnect the electrical connectors.
Installation Procedure
1. Connect the electrical connectors, if necessary.
2. Align the retainers with the holes in the door.
3. Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the trim panel screws.
Tighten the trim panel screws to 2 N.m (18 lb in).
5. Install the manual lock lever by pressing the lever until the lever is completely seated.
6. Connect the electrical connector to the reflector lamp, and install the reflector by pressing the reflector until the reflector is completely seated, if
removed.
7. Install the window-regulator handle, if necessary.
8. Install the door handle bezel.
Trim Panel Replacement - Upper Extension
TRIM PANEL REPLACEMENT - UPPER EXTENSION
REMOVAL PROCEDURE
1. Open the front door.
2. Release the upper extension by pulling outward on the front edge in order to release the upper retainer clips.
3. Remove the upper extension from the trim panel by lifting up and out.
INSTALLATION PROCEDURE
