chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Body/Steering - Clunk Noise When Turning|Page 18491 > < Body/Steering - Clunk Noise When Turning|Page 18489
Page 4
background image

For vehicles repaired under warranty, use the table.

Disclaimer

Technical Service Bulletin # 03-08-61-002I

Date: 070827

Body/Frame - Front End Snapping or Popping Noises

Bulletin No.: 03-08-61-002I

Date: August 27, 2007

TECHNICAL

Subject:
Snap/Popping Type Noise Coming from Front of Vehicle (Remove Bolt-In Front Crossmember and Add Washers)

Models:
2003-2006 Cadillac Escalade
2003-2006 Chevrolet Avalanche, Suburban, Tahoe
2004-2007 Chevrolet Silverado (Classic)
2003-2006 GMC Yukon, Yukon XL
2004-2007 GMC Sierra (Classic)
2003-2008 HUMMER H2

1500 Series (1/2 Ton) and 2500 Series (3/4 Ton) with Two-Wheel Drive

Attention:

This bulletin only applies to 1500/2500 Series 2WD and HUMMER H2 vehicles with recirculating ball type steering.

Supercede:

This bulletin is being revised to update the parts information to include a new washer for HUMMER H2. Please discard Corporate Bulletin Number
03-08-61-002H (Section 08 - Body and Accessories).

Condition

Some customers may comment on a snap or popping-type noise coming from the front of the vehicle. This condition is most apparent during hard left or
right turns at low speeds. Going over bumps while turning may also aid in producing this noise.

Correction

Body/Steering - Clunk Noise When Turning|Page 18491 > < Body/Steering - Clunk Noise When Turning|Page 18489