Silverado 1500 2WD V8-4.8L VIN V (2006)
Seat Cushion: Procedures
Seat Cushion Cover and Pad Replacement - Rear
SEAT CUSHION COVER AND PAD REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the rear seat from the vehicle.
2. Remove the rear passenger seat riser.
3. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
4. Disconnect the rear heater connector, if equipped.
5. Remove the seat belt buckles, if required.
6. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
7. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
8. Remove the center screw retaining the latch cover, if equipped.
9. Remove the seat cushion cover from the foam pad.
INSTALLATION PROCEDURE
1. Install the seat cushion cover to the foam pad.
2. Install the center screw retaining the latch cover, if removed.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screw to 2 N.m (18 lb in).
3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
4. Install the seat buckles, if removed.
5. Connect the rear heater connector, if equipped.
6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
7. Install the rear passenger seat risers.
8. Install the rear seat to the vehicle.
Seat Cushion Frame Replacement - Front
