Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Remove the I/P carrier.
2. Disconnect the electrical connector (4) from the right air temperature actuator (3).
3. Remove the screws from the right air temperature actuator (3).
4. Remove the right air temperature actuator (3) from the HVAC module assembly (2).
INSTALLATION PROCEDURE
1. Install the right air temperature actuator (3) from the HVAC module assembly (2).
2. Install the screws to the right air temperature actuator (3).
Tighten the screws to 2 N.m (18 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the right air temperature actuator.
4. Install the I/P carrier.
5. Reprogram the air temperature actuator. Refer to Re-Calibrating Actuators.
Air Temperature Actuator - Left
AIR TEMPERATURE ACTUATOR REPLACEMENT - LEFT
REMOVAL PROCEDURE
1. Remove the center console, if equipped.
2. Remove the instrument panel (I/P) insulator panel.
3. Disconnect the electrical connector (1) from the left air temperature actuator (2).
4. Remove the screws from the left air temperature actuator (2).
5. Remove the left air temperature actuator (2) from the HVAC module assembly (3).
INSTALLATION PROCEDURE
