Silverado 1500 2WD V8-4.8L VIN V (2006)
1. Install the air temperature actuator.
2. Install the air temperature actuator retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector (8) to the air temperature actuator (9).
4. Install the IP insulator.
Air Temperature Actuator - Left
AIR TEMPERATURE ACTUATOR REPLACEMENT - LEFT
REMOVAL PROCEDURE
1. Remove the I/P insulator panel.
2. Disconnect the electrical connector (1) from the left air temperature actuator (2).
3. Remove the screws from the left air temperature actuator (2).
4. Remove the left air temperature actuator (2) from the HVAC module assembly (3).
INSTALLATION PROCEDURE
