Silverado 1500 2WD V8-4.8L VIN V (2006)
Fluid - Differential: Service and Repair
Lubricant Level Inspection - Rear Drive Axle (9.5 Inch HD and 10.5 Inch Axles)
Lubricant Level Inspection - Rear Drive Axle (9.5 Inch HD and 10.5 Inch Axles)
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Make sure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.
5. Remove the rear axle fill plug.
6. Inspect the lubricant level.
The lubricant level should be between 0 - 10 mm (0 - 0.4 inch) below the fill plug opening.
7. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and
Lubricant Recommendations.
8. Install the rear axle fill plug.
^
Tighten the rear axle fill plug to 33 Nm (24 ft. lbs.).
Notice: Refer to Fastener Notice.
9. Lower the vehicle.
